Heat‐Treatment and Water Immersion Effect on the Mechanical Properties and Joint Strength of 3D‐Printed Polylactic Acid Parts
Yazarlar (2)
Doç. Dr. Fatih Huzeyfe ÖZTÜRK Karabük Üniversitesi, Türkiye
Doç. Dr. Özkan ÖZ Karabük Üniversitesi, Türkiye
| Makale Türü | Özgün Makale (SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale) | ||
| Dergi Adı | Polymers for Advanced Technologies (Q2) | ||
| Dergi ISSN | 1042-7147 Wos Dergi Scopus Dergi | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 10-2024 |
| Cilt / Sayı / Sayfa | 35 / 11 / 1–14 | DOI | 10.1002/pat.6624 |
| Makale Linki | https://doi.org/10.1002/pat.6624 | ||
| UAK Araştırma Alanları |
Eklemeli İmalat
|
||
| Özet |
| This paper investigates the effect of short‐time water immersion (WI) and heat‐treatment (HT) post‐processes on the mechanical properties and joint strength of printed polylactic acid (PLA) parts with various raster angles. Using these post‐processing methods to enhance the joint strength of printed PLA parts could be deemed as the novelty and the contribution of the current study. The WI and HT of the tensile test specimens and the adherends of the bonded joints were carried out at 21°C and 90°C, respectively. Depending on the raster angle, the tensile strength of the heat‐treated specimens was about 11%–43% higher than that of the untreated specimens. Interestingly, it was found that WI had a more significant effect on the strength of printed parts than HT. In the case of WI, the tensile strength was increased by about 27%–57% as compared to the untreated specimens. Joint tests revealed that HT and WI … |
| Anahtar Kelimeler |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Google Scholar | 11 |