The effect of adhesive and adherend compliance on the failure of 3D-printed parts
Yazarlar (2)
Doç. Dr. Özkan ÖZ Karabük Üniversitesi, Türkiye
Doç. Dr. Fatih Huzeyfe ÖZTÜRK Karabük Üniversitesi, Türkiye
| Makale Türü |
Özgün Makale
(SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | Welding in the World (Q2) | ||
| Dergi ISSN | 0043-2288 Wos Dergi Scopus Dergi | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 04-2025 |
| Cilt / Sayı / Sayfa | 69 / 9 / 2869–2883 | DOI | 10.1007/s40194-025-02048-9 |
| Makale Linki | https://doi.org/10.1007/s40194-025-02048-9 | ||
| UAK Araştırma Alanları |
Eklemeli İmalat
|
||
| Özet |
| The present study deals with the adhesive selection for extrusion-based 3D-printed parts. The compatibility of acrylate (AC), polyurethane (PU), methyl methacrylate (MM) and epoxy (EP) adhesives with polylactic acid (PLA), polyethylene terephthalate glycol (PETG), acrylonitrile butadiene styrene (ABS), and acrylonitrile styrene acrylate (ASA) adherends was investigated. Tensile tests were conducted to provide enhanced knowledge on the failure behavior of these joints. Taguchi L16 orthogonal array and analysis of variance (ANOVA) were used to the design of experiment (DOE) and to identify the contribution of each parameter on the response, respectively. In addition, a closed-form solution of critical stress (peel and shear stresses) distributions along the bondline was used to gain a better insight into the failure mechanism of joints considered in this study. The ANOVA results showed that the effect of adhesive … |
| Anahtar Kelimeler |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Google Scholar | 5 |