A comprehensive experimental study of the potential use of 3D printable thermoplastic polymers as structural adhesives
Yazarlar (2)
Doç. Dr. Özkan ÖZ Karabük Üniversitesi, Türkiye
Doç. Dr. Fatih Huzeyfe ÖZTÜRK Karabük Üniversitesi, Türkiye
| Makale Türü |
Özgün Makale
(SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | The International Journal of Advanced Manufacturing Technology (Q2) | ||
| Dergi ISSN | 0268-3768 Wos Dergi Scopus Dergi | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 04-2025 |
| Cilt / Sayı / Sayfa | 137 / 11 / 6073–6090 | DOI | 10.1007/s00170-025-15532-9 |
| Makale Linki | https://doi.org/10.1007/s00170-025-15532-9 | ||
| UAK Araştırma Alanları |
Eklemeli İmalat
|
||
| Özet |
| This paper deals with the potential use of 3D printable thermoplastic polymers as structural adhesives. Acrylonitrile butadiene styrene (ABS), polylactic acid (PLA), polyethylene terephthalate glycol (PETG), and thermoplastic polyurethane (TPU) were used as thermoplastic adhesive. The assembly of the steel adherends with thermoplastic adhesives was conducted by using induction heating (IH). Thick adherend shear test (TAST) was performed to evaluate the shear load capacity of adhesives. Tensile and three point-bending (3P-B) tests of the single lap joint (SLJ) were carried out to evaluate the performance of adhesives under in-plane and transverse loadings. According to experimental results, PETG showed the best performance among the other adhesives for the shear and tensile loadings. The maximum shear load of PETG is about 102% higher than that of TPU, which has the lowest shear load capacity. A … |
| Anahtar Kelimeler |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Google Scholar | 14 |